Specifications

22
Getting Started
Page 19
>Embedded Features
Sub-menu
Use this menu to enable ROM extensions embedded in the
Flash Boot Device (FBD). For more information, refer to
the section concerning the Embedded Features Sub-menu.
System Memory
You cannot edit this field and it is not necessary to do so.
The field shows the amount of conventional memory (that
below 1 MB) available.
NOTE: The amount of conventional memory is actually
less than 640 KB, as the extended BIOS data area uses
some of this memory to support the PS/2 mouse interface.
Extended Memory
You cannot edit this field and it is not necessary to do so.
The field shows the amount of extended memory (that
above 1 MB) available.
>IDE Adapter Sub-menus
There are two IDE Adapter Sub-menus: one for a master drive
(bootable) and one for a slave drive (not bootable). The EPC-30
supports a maximum of two hard disk drives. To see detailed
characteristics of the device set up as the master drive or to change
the configuration of the drive, choose the IDE Adapter 0 Master
Sub-menu. Choose the IDE Adapter 0 Slave Sub-menu to configure
or change a second drive. Figure 2-4 shows the IDE Adapter 0
Master Sub-menu.