Specifications

22
Getting Started
Page 11
If damage has occurred in shipment, notify the carrier at once to initiate a
damage claim. Contact your dealer or RadiSys customer service for
replacement of damaged products. The RadiSys customer service telephone
number appears on the front cover of this manual.
Make sure you take great care in providing protection from Electro-Static
Discharge (ESD).
DO NOT REMOVE ANY MODULES FROM THEIR ANTI-
STATIC BAGS UNLESS YOU ARE IN A STATIC-FREE
ENVIRONMENT
. THE EPC-30, LIKE MOST OTHER
ELECTRONIC DEVICES
, IS SUSCEPTIBLE TO ESD
DAMAGE
. ESD DAMAGE IS NOT ALWAYS IMME-
DIATELY OBVIOUS -IT CAN CAUSE A PARTIAL
BREAKDOWN IN SEMICONDUCTOR DEVICES THAT
MIGHT NOT IMMEDIATELY RESULT IN FAILURE
.
Mounting and Installation
Install the EPC-30 in a suitable enclosure using mounting holes or desktop
fashion. Ensure that environmental conditions in the enclosure will
consistently meet the conditions shown in the product specifications in
Chapter 1. Figure 2-1 shows the board dimensions and mounting hole
locations.
NOTE: If the EPC-30 installation location provides limited accessibility,
check the jumper settings on the board before you install it. Refer to the next
section for information on how to set jumpers on the board.