Specifications

Introduction
11
Page 3
• 2/4/8Mb Intel SmartVoltage boot-block Flash EPROM containing BIOS
(4Mb part populated)
• One 72-pin SIMM socket providing the capability for 1MB to 16MB of
DRAM
• Pad patterns for 1MB, 2 MB or 4 MB soldered down DRAM
configurations
• IC Works W48C54A-59 clock generator chip with resistor options for
33/40/50/66MHz CLK2 selection. Note that the CPU runs at half the clock
speed.
• One Resident Flash Array (RFA) site for 1 MB, 2MB or 4 MB parts
• Cirrus Logic PD6710 PCMCIA controller on the ISA bus
• Optional PC-104 form-factor daughter card that supports Type I, II and
III PCMCIA cards
• LCD/VGA controller on the Intel386 EX local bus (Cirrus Logic
GD6245 with 512K RAM)
• Standard D-SUB 15-pin VGA connector and 10-pin header
• Three RS232C serial ports available through one standard DB9
connector and two 10-pin headers (using the “commonly available” pinout
rather than the “IDC connector cable” pinout). COMA provided by the
Intel386 EX; COMB & COMC provided by the Super I/O chip
• PS/2 compatible keyboard interface via a 6-pin mini-DIN connector and
a stake-pin header
• PS/2 compatible mouse interface via a stake-pin header
• Floppy drive controller using programmed I/O (not DMA) that is
accessed through a standard header connector. Supports power through the
cable in standard configurations (can be disabled)
• Enhanced parallel printer port (LPT1) that is available through a 26-pin
stake pin header using the commonly available pinout
• Standard 44-pin IDE interface connector, supporting 2.5” and 3.5”
drives and providing power through the cable
• Standard PC/104 socket
• ISA bus card-edge connector
• Reset jumper on Misc. connector
• Keyed PC FDD power connector (+12, GND, GND, +5) can provide
power to the board