Specifications

Reflashing the Flash Boot Device
DD
Page D-16
Command line parameters are:
/F=<filename> File (in absolute binary format) to be
flashed into the
device.
/O Offset (in HEX) at which to begin
flashing; offsets
are relative to the lowest address of the
device; these are not physical memory
addresses. See the offset values in Figure D-1.
An offset of zero specifies that flashing is
to begin at the very first byte of the
device.
/SSuppress reboot. Suppresses the
automatic reboot at completion of
the reflashing process. Use this option with care.
New images you flash into the FBD are not
immediately effective as the EPC-30 supports
BIOS shadowing.
/CClear CMOS setup information stored in
the FBD. Some RadiSys products allow you to
store CMOS setup information in
the FBD. This information, when stored,
resides in Parameter Block 2. See Figure D-1. Invoking
the /C option clears Parameter Block 2,
clearing the stored CMOS setup
information from the FBD. The EPC- 30
does not allow you to store CMOS setup information
in the FBD.
/PPhysical base address of device being
reflashed.
When the flash update is complete and the binary images you
specified are written into the FBD or RFA, the system reboots with