Specifications

11
Page 1
-
Introduction
Purpose
This manual contains information about the EPC-30 single board computer.
The purpose of this manual is to fully explain the standard software and
hardware that ships with each EPC-30.
About This Manual
This manual assumes that the reader possesses a good working knowledge of
microcomputer system architectures and peripheral devices. Use this manual
to install and set up the EPC-30 to suit your application.
This manual consists of the following chapters and information:
Chapter 1 Introduction. This chapter provides an overview of the
EPC-30 and includes electrical and environmental specifications.
Chapter 2 Getting Started. Provides information about how to install
the
EPC-30, set jumpers on the board, set up the Phoenix BIOS, power up the
board, and boot an operating system.
Chapter 3 Theory of Operation. Contains detailed information about
the on-board processor, memory, chipset, and peripheral interfaces.
Chapter 4 Connectors. Provides pinout diagrams and other
information about the connectors and headers on the board.
Chapter 5 Troubleshooting and Error Messages. Provides a list of
error
messages you may encounter and how to resolve error causes.
Chapter 6 Support and Service. Provides information about how to
contact technical support engineers regarding this product.
Appendix A Chipset and I/O Map. Provides information about registers
and the I/O map.
Appendix B IRQ Map. Lists the IRQs used by the EPC-30.
Appendix C VGA Interface. Describes the optional Cirrus Logic
software and VGA drivers.
Appendix D Reflashing the Flash Boot Device. Provides in-depth
information about the reflashing the EPC-30 BIOS.
Appendix E LCD Flat Panel Interface. Describes how to build cables
for flat panels supported by the Cirrus Logic VGA chip.
Appendix F PC Card Interface. Defines supported EPC-30 PC card
interfaces and optional Card and Socket Services software.