Specifications

Chapter 3: Installation
Page 21
33
EXP-BP6 Subplane
The EXP-BP6 subplane is used
in a configuration to couple an
EPC-5A processor module with
an EXP-MX Mass Storage
module and either
• two EXP-MC Module
Carriers
or
•
one EXP-AM
Adapter Module.
The EXP-BP6 has eight
connectors on the front side
and seven on the rear.
Plug the subplane into the
VMEbus backplane such that
the P2 connector on the back of
the 4-row DIN is pressed into
the J2 connector of the left-
most VMEbus slot that the
EPC-5A subsystem will
occupy.
The subplane has holes for op-
tional bolting to the VMEbus
backplane using the screws included.
The EXM slot numbers are shown in the drawing.
Figure 3-6. EXP-BP6 Subplane.