Specifications

Chapter 3: Installation
Page 19
33
EXP-BP5 Subplane
The EXP-BP5 subplane is used
in a configuration to couple an
EPC-5A processor module with
an EXP-MC Module Carrier
and an EXP-MX Mass Storage
module. The EXP-BP5 has six
connectors on the front side and
five on the rear.
After jumpering the back-
plane, plug the subplane into
the VMEbus backplane such
that the P2 connector on the
back of the 4-row DIN is
pressed into the J2 connector of
the left-most VMEbus slot that
the EPC-5A subsystem will
occupy.
The subplane has holes for op-
tional bolting to the VMEbus
backplane using the screws
included.
The EXM slot numbers are
shown in the drawing.
Figure 3-4. EXP-BP5 Subplane.