Specifications

Appendix C: Flash Boot Device
Page C-7
CC
The Reflash Flash update program requires the /F and /O command line
arguments; the /P is optional. This information may be displayed by typing
Reflash with no parameters:
/F=<filename> File to be flashed; multiple file names may be specified.
/O Offset to begin flashing; offsets are
relative to the lowest address of the
flash device; these are not PC
addresses. For example, an offset
of zero specifies that flashing is to
begin at the very first byte of the
flash device.
/C Erase CSR data if it exists and
invalidate CMOS data parameter
data. This option is recommended
for BIOS reflashes. If the System
CMOS data map changes, the
CMOS data and its map will be
inconsistent.
/S Suppress rebooting after successful
execution. This option is useful
for execution from batch files.
/P Physical base address of the region
to be flashed. This parameter does
not apply to the EPC-5A. If this
switch is omitted, the FBD is the
default reflash target.
To update the FBD, follow the instructions below:
1. Run: Reflash /F=[update_file_name] /O=0 to begin the update.
2. The following message displays:
“Update completed successfully. Press any key to reboot.”