Specifications

EPC-33/34 Hardware Reference
Page C-8
C C
No NIC. DMA Failure
These messages display when a fault is detected in the AT/LANTIC chip on the
Ethernet controller. This is a fatal hardware error. Contact RadiSys Technical
Support.
Incorrect PROM ID Byte
This message displays when there is a hardware problem in the EEPROM. I/O mode
is thus disabled. Contact RadiSys Technical Support.
(xfer to memory)
(xfer from memory)
Failed after X bytes with X
These messages display if there is a problem during the Buffer Memory test. The
first two messages highlight errors in the transfer of data. The third message
identifies where the data transfer error occurred. This is a fatal hardware error.
Contact RadiSys Technical Support.
Cable Disconnected
Cable Unterminated
These messages indicate faults in the cabling or connection. Check to see if the
network cable is in proper working order, properly connected and terminated. If the
connections are proper and the termination is acceptable, the cables are faulty. If the
cable tests good in another system, the connection is faulty.
No Interrupt
This message displays during the Interrupt Assignment test if the interrupt selected
is not active. Return to the setup function and select another interrupt listed as
available.