Specifications

Appendix C - Ethernet
Page C-7
C C
The following displays while several options are checked:
Network Interface Controller (12-byte node address).............. OK
Buffer Memory Check............................................................ OK
Check Cable Connection (Cable Connected) .......................... OK
Interrupt Assignment (5)........................................................ OK
Boot PROM Check (No Boot PROM)..................................... OK
Press ESC to return to the previous menu. If Diagnostics reveals an error, return to
the Display/Change configuration menu and make the necessary changes. Run
Diagnostics again.
Error Messages
The AUTOSET software has several associated error messages that may display
during operation. AUTOSET error messages are explained below.
Out of memory error
This message displays only during development and should never display during
normal operation. If this message displays, contact RadiSys Technical Support.
No adapter at this address
This message displays when the address selected does not have an Ethernet
controller network adapter card attached. Check the hardware to make sure the
Ethernet controller is present. If the message continues to display, select another
address such as 300h, 280h, etc. If an address change does not fix the problem, the
Ethernet controller chip has failed.
No interrupt available for configuration
This message displays when there is no free interrupt to assign to the Ethernet
controller. The only solution is to determine where all the interrupts are configured,
and to free an interrupt that is redundant or unnecessary, such as COM2 or LPT1.
Cannot initiate an adapter with a disabled interrupt
This message displays when a disabled interrupt has been selected. Retry with a
valid interrupt selection.