Specifications

Appendix C - Ethernet
Page C-3
C C
5. Select the Physical Media cabled up: only 10BaseT is available for the
EPC-33/34.
6. Select the Adapter architecture. Use "I/O Port" for NE2000 mode, or use
"Shared Memory" for Western Digital mode.
7. Skip the Boot PROM prompt. It does not apply to the EPC-33/34.
8. Save the configuration to the on-board memory only if your system is currently
not connected to the network. If you are experiencing difficulties, save as
temporary changes to determine if they work correctly, then run AUTOSET
again and save the changes as permanent.
9. Run Diagnostics to verify the setup. If using Western Digital mode, specify a
shared memory base address to be used during diagnostics. Also, to guard
against conflicts, exit Diagnostics and check that any EMM386 entries in the
CONFIG.SYS file and SYSTEM.INI file (if using Windows) both exclude the
memory assignment to the Ethernet controller. If the system does not pass the
Diagnostics, try again, changing the indicated parameters.
10. Press ESC to return to the previous menu.
If only one Ethernet controller is to be installed, the configuration procedure is
complete. Exit the AUTOSET program and turn to the section Configuring the
Ethernet Drivers.
The responses entered from the AUTOSET configuration menu depicted in the
previous figure are discussed in detail below.
Novell Configuration
There are several pre-set Novell Configuration options programmed into the
AUTOSET program that are not applicable to the EPC-33/34. The Novell
Configuration option must be set to None.