Specifications

EPC-33/34 Hardware Reference
Page C-2
C C
The Ethernet 1 of 2 distribution diskette contains the setup program AUTOSET,
and a collection of drivers for various network interfaces and operating systems.
Ethernet 2 of 2 contains additional drivers.
The installation program assumes you have DOS in your PATH statement.
Using the AUTOSET
Make sure that network software is NOT currently running on the computer system.
If network software is running, reboot or unload the network software.
To start the program, move to the Ethernet controller subdirectory and type
AUTOSET, then press Enter. The Main Menu displays.
The following options are in the Main Menu: Display/Change Adapter
Configuration, Diagnostics, and Quit.
To initialize an Ethernet controller for the first time, to change the configuration, or
to configure multiple Ethernet controllers, select "Display/Change Adapter
Configuration" in the AUTOSET Main Menu.
To diagnose problems or verify the configuration, select "Diagnostics."
Note: If more than one Ethernet controller requires configuration for the first time,
see the section Configuring Additional Ethernet Controllers.
Configuring an Ethernet controller with AUTOSET
For a single Ethernet controller installation, follow these steps:
1. From the AUTOSET program, select "Display/Change Adapter Settings" to set
up the Ethernet controller just installed.
2. Skip the Novell Configuration prompt. It does not apply to the EPC-33/34.
3. Select the I/O base address. Use the tab key to change the Ethernet controller's
I/O base address to any available location. Note: 300h is recommended because
it allows the use of most network software drivers without modification.
4. Select the Interrupt Assignment. Be sure to avoid any interrupts used by other
interfaces in the system.