Specifications

Page C-1
C C
Appendix C -
Ethernet
This Appendix describes how to configure the Ethernet adapter on the EPC-33/34,
including how to run the AUTOSET software and how to configure the Ethernet
driver appropriate to your operating system.
AUTOSET Software
The AUTOSET program is used to configure the Ethernet controller. Since this
may be set up by your supplier, you may never be required to use this program. The
software is contained on the optional Ethernet 1 of 2 software diskette that is an
optional item for the EPC-33/34. The AUTOSET program must be run from DOS
or a DOS shell and enables the following actions:
• Select one adapter to be configured. Up to four adapters may be installed.
• Manually select configuration options (such as I/O base address and IRQ)
for a specific installation.
If configuring multiple Ethernet controller cards in a single system, refer to the
section, "Configuring Additional Ethernet Controllers."
Installing the Software
Under DOS 5.0 or higher, or in a DOS window, insert the Ethernet 1 of 2
distribution diskette in the floppy drive and switch the command line to that floppy
drive. The DOS INSTALL.BAT file creates a subdirectory on the hard disk and
copies the collection of software drivers and configuration files from the distribution
disks to the hard disk. Type Install and press Enter. Note that AUTOSET can be
run from a floppy disk drive.