Specifications

EPC-33/34 Hardware Reference
Page 38
3 3
Resetting the EPC
There are a number of ways to reset (reboot) the EPC.
Power-off, Power-on
This causes the entire system to reset. The system runs the power-on self-
tests and reboot the operating system.
External Reset Input
The external reset input causes the EPC-33/34 to perform a hardware reset.
The system runs the power-on self-tests and reboot the operating system.
BIOS Setups EXIT Screen
From the EXIT screen, when you exit and save changes a reboot causes a
hardware reset. The system runs the POST and reboots the operating
system. It does not cause an AT reset.
CTRL+ALT+DEL
This keyboard sequence is called a "warm boot." The EPC does not
reinitialize all of the processor's hardware. The power-on self-test does not
run. However, the operating system will be reloaded. This type of reset
typically only works under DOS.
Watchdog timer
This causes the entire system to reset. The system runs the power-on self-
tests and reboot the operating system. See below for more details.
Additional abnormal conditions that cause a reset
Low Vcc