Specifications

EPC-33/34 Hardware Reference
Page 18
2 2
1. A: then C: Used to boot from the floppy disk drive, or if no floppy is
present in the A: drive, boot from the C: drive.
2. C: then A: Used to boot from the C: drive, whether Flash or IDE, or
if none is present, boot from the A: drive.
3. C: only Used to boot from the C: drive without searching for an A:
drive.
The default is A: then C:. The setting chosen here displays in the Boot Sequence
Sub-menu prompt.
SETUP Prompt:
Use this option to enable or disable the message “Press F2 to enter Setup.” Even if
the message is disabled, you can still press <F2> to enter the Setup Menu. The
default is to enable this prompt.
POST Errors:
Use this option to stop during the boot if the system encounters error messages.
Otherwise, the system will continue to attempt to boot despite any startup error
messages that display. The default is to enable this option, meaning the system will
stop on encountering errors during the POST process.
Floppy check:
Use this option to enable or disable the floppy drive search during the boot. To speed
up booting, you can disable the floppy check. It is still possible to boot from the A:
drive even with the floppy check disabled. The default is to enable the floppy check.
Summary screen:
Use this option to enable or disable a summary of the system configuration, which
displays before the operating system starts to load. To save time, you can disable the
summary screen. The default is to enable the summary screen display.
When you have completed the Boot Options Menu, exit back to the Main BIOS
Setup Menu using the ESC key and complete the Keyboard Features Sub-menu.