Specifications

Installation and Configuration

Page 11

2 2

During the setup and configuration of the EPC-33/34, a monitor and keyboard are

required. A hard drive is recommended.

Whenever a hardware reset of the EPC occurs the system performs a power-on self-

test (POST). The POST displays information showing the status of the BIOS self-

test.

In the case below, floppy drive A: is not configured correctly. The screen image

displays approximately as shown.

PhoenixBIOS Version 4.04

CPU = INTELDX4 100 Mhz

0000640K System RAM Passed

0003072K Extended RAM Passed

System BIOS Shadowed

Video BIOS Shadowed

UMB upper limit segment address: F673

Diskette drive A error

Press <F1> to resume, <F2> to Setup

Figure 2-4. POST Display with Error.

If errors occur during the power-on self-test, the BIOS displays the error on the

appropriate line of the screen display and continues the boot process. It is important

to watch the POST display to verify that no errors occur.

If error messages are displayed during or after the POST display, see Chapter 5,

Error Messages.