Specifications

EPC-33/34 Hardware Reference
Page 8
2 2
Mounting Holes
Six mounting holes are positioned on the PCB to allow for alternate mounting of the
EPC-33/34 in something other than an ISA-bus chassis. These holes are located near
the corners of the board and in the middle of the board top and bottom edges. Four
of the holes are positioned to also be used as mounting holes for PC/104 module(s).
The locations of the mounting holes are shown below. All dimensions are in inches.
Figure 2-2. EPC-33/34 Dimensions.
The highest component on the board is the speaker, which extends 0.55” above the
PCB. However, the end plate extends 0.75” above the PCB on the top flange.
To mount the EPC-33/34 to a surface using the screw holes, be sure to select
a location where you have access to all available header pins and
connectors. Mounting holes on the EPC-33/34 are 1/8" (0.125") in diameter,
or 3.175 mm.
Refer to Figure 2-2 for a depiction of the EPC-33/34 mechanical dimensions.
Refer to Figure 2-3 for a depiction of the EPC-33/34 layout.