Specifications

Introduction
Page 5
1 1
About This Manual
This manual is divided into the following:
Chapter 1 Introduction. Describes product, provides environmental and
electrical specifications, and contains an overview of this manual.
Chapter 2 Installation and Configuration. Provides complete instructions on
how to do the following: set jumpers, provide power, connect
peripherals, mount, or install in a backplane, etc.
Chapter 3 Theory of Operations. Contains detailed information on memory,
chipsets, Flash, SRAM, etc.
Chapter 4 Connectors. Provides pinout information for each connector.
Chapter 5 Error Messages. Contains recovery information for errors.
Chapter 6 Support and Service. Lists RadiSys support and service contacts.
Appendix A Chipset and I/O Mapping. Provides information about registers
and the I/O map.
Appendix B IRQs and DMA. Lists the IRQs and DMA channels.
Appendix C Ethernet. Describes the AUTOSET software and how to configure
the Ethernet device drivers.
Appendix D LCD Cabling. Provides LCD cabling information.
Appendix E VGA. Describes the Cirrus Logic software and VGA drivers.
Appendix F Flash Formatting Software. Explains how to format the Flash and
configure the Flash device driver.
Appendix G Enabling the SRAM. Describes how to configure SRAM drivers
and
how to format the SRAM.