Specifications

EPC-33/34 Hardware Reference
I-4
I I
F
FIFOs
on COM ports, 38
Flash
configuring as bootable device, 16
Flash BIOS extensions, 16
Flash boot-image, F-2
Flash device
backing up CMOS, 25
contains system BIOS and video
BIOS, 29
parameter blocks, 29
flash disk
erasing and writing (voltage
requirements), 31
memory window, 31
programming voltage bit, 32
subsystem explained, 31
used for booting, 31
flash EPROM
8-bit wide, 28
Flash memory
booting, 17
Flash ROM disk, 24
Flash ROMdisk BIOS extension, 21
flat panel, 30
flat panel and VGA monitor on one
system, 7
flat panel backlight control
software programmable, 2
flat panel connector
pinout, 47
flat panel contrast control, 2
software programmable, 2
flat panel display, 29
backlight control, 30
contrast control, 30
jumpers, 6
flat panel setup
using CLMODE, E-5
flat panels, 7
cabling instructions, D-1
Floating Point
interrupt usage, B-1
floppy check
setup, 18
floppy disk controller, 39
DMA channel usage, B-2
interrupt usage, B-1
I/O address map, A-3
setup, 13
floppy disk drive controller connector
pinout, 50
Floppy disk drives, 13
floppy diskette errors, 59
floppy drive
connection, 10
floppy drive controller, 2
floppy drive search, 18
floppy drives
use of twisted cable for drive B:, 39
Force BIOS Recovery jumper, 6
formatting resident flash arrays (RFAs),
F-1
G
general failure, 63
GUI acceleration
supported, 29
H
hard disk drive access LED, 36
hard disk drives
setup for 32-bit I/O, 16
hard disk failure, 59
hard drive
connection, 10
recommended, 11
hardware reset, 11