Specifications

EPC-33/34 Hardware Reference
Page C-12
C C
NDIS Driver for DOS Installation
The NDIS ETHAT2 driver is used for 16-bit Western Digital mode and 16-bit
NE2000 mode for the NDIS interface. It is used by various protocol stacks and
applications, such as Windows for Workgroups (WFW). NDIS 3.0 protected mode
support is already included in WFW. The steps below would be part of a typical
setup for NDIS 2.0 real mode.
1. Set up PROTOCOL.INI according to the environment. To set up
ETHAT2
for NE2000 using IRQ5 and I/O base address 300, refer to the example
below.
[EPC-34]
DriverName=ETHAT20$
IOBASE=0x300
INTERRUPT=5
[MS$NETBEUI]
DriverName=netbeui$
SESSIONS=10
NCBS=32
LANABASE=1
BINDINGS=EPC-34
[NETBEUI]
LANABASE=1
BINDINGS=EPC-34
2. At the command line, enter NET START WORKSTATION.
3. At the command line, enter NET VIEW to verify access to other
computers.
Packet Driver Installation
The diskettes distributed with the EPC-33/34 contain two packet drivers named
ATDRIVE.COM (for 16-bit NE2000 mode) and WD8003E.COM (for 16-bit
Western Digital mode). RadiSys also supplies files named TELBIN (a Telnet