Specifications

Appendix C - Ethernet
Page C-11
C C
ODI Driver for OS/2 Installation
The steps below outline a typical procedure for accessing the Novell NetWare
Requester using the ODI interface running under OS/2:
1. Open a DOS window.
2. Run AUTOSET. Set the IRQ=5, I/O port address=300, and select the
adapter architecture.
3. Save and exit AUTOSET.
4. Install the OS/2 Workstation Service Requester (1 disk) and the OS/2
Utilities (2 disks) supplied with the Novell Network software.
5. Run INSTALL from C:\NETWARE to select and load
NE2000.SYS. After the installation CONFIG.SYS should contain the
following section:
DEVICE=C:\NETWARE\LSL.SYS
RUN C:\NETWARE\DDAEMON.EXE
DEVICE=C:\NETWARE\NE2000.SYS
DEVICE=C:\NETWARE\IPX.SYS
DEVICE=C:\NETWARE\SPX.SYS
RUN C:\NETWARE\SPDAEMON.EXE
DEVICE=C:\NETWARE\NWREQ.SYS
IFS=C:\NETWARE\NWIFS.IFS
RUN=C:\NETWARE\NWDAEMON.EXE
6. Modify/create NET.CFG according to the environment. For example:
Link Driver NE2000
Frame Ethernet_802.3
Protocol IPX
Port 300 f
7. Reboot the system.