Specifications

EPC-33/34 Hardware Reference
Page C-10
C C
The NE2000.COM driver supplied on the EPC-33/34 distribution diskettes is
preconfigured for use with the Ethernet 802.3 interface. If your network requires
operating multiple protocols on top of a single card, use the ECONGIF program
provided by Novell to change the NE2000.COM interface setting to Ethernet II.
The ATLANIC.COM driver is used in 16-bit Western Digital mode with the IPX
interface. Once the EPC-33/34 is configured using AUTOSET, and the distribution
diskettes are loaded onto the system, modify the AUTOEXEC.BAT file by entering
these commands at the end of the file:
ATLANIC /o0 (run ATLANIC /D to display available options)
NETX.COM (provided by network software or operating
system distribution diskettes)
ODI Driver for DOS Installation
The Open Data-Link Interface (ODI) adds functionality to NetWare and network
computing environments by supporting multiple protocols and multiple LAN
adapters in a single workstation. Refer to the Novell NetWare ODI Shell for DOS
manual for additional installation instructions.
Once the EPC-33/34 is configured using AUTOSET, and the distribution diskettes
are loaded onto the system, use a text editor to modify the NET.CFG file to match
the AUTOSET parameters. The interrupt, I/O address, mode, and interface type
must all match.
Then add the following programs into the AUTOEXEC.BAT file:
LSL.COM Link support layer
ATLANTIC.COM Multiple Link Interface Driver
IPXODI.COM IPX/SPX Protocol
NETX.COM (provided by operating system or workstation
distribution diskettes)
While editing the AUTOEXEC.BAT file, make sure that the path= statement
includes the directory containing the NET.CFG file.
The ATLANTIC.COM driver is used for the ODI interface in 16-bit Western
Digital mode and 16-bit NE2000 mode. The ODI interface does not support IRQ15.