Specifications

EPC-8 Hardware Reference
E E
E-4
EXP-BP4 Subplane
The EXP-BP4 subplane is used to
couple an EPC-8 processor module,
two TXM modules, and an EXP-MX
Mass Storage module.
The EXP-BP4 is a T-shaped board
with four connectors on the front
side and three on the rear.
After jumpering the backplane, plug
the subplane into the VMEbus
backplane such that the P2 connector
on the back of the 4-row DIN is
pressed into the J2 connector of the
left-most VMEbus slot that the
EPC-8 subsystem will occupy.
The EXM slot numbers are shown in
the drawing.
Figure E-3. EXP-BP4 Subplane.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com