Specifications

Subplanes
E E
E-3
EXP-BP2 Subplane
This subplane is to provide connectivity for
the processor and two EXM modules.
The EXP-BP2 is an L-shaped board with
three connectors on each side.
After jumpering the backplane, plug the
subplane into the VMEbus backplane such
that the P2 connector on the back of the 4-
row DIN is pressed into the J2 connector
of the left-most VMEbus slot that the EPC-
8 subsystem will occupy.
The lower EXM connector is denoted as
EXM slot 0 and the upper as slot 1 as
shown in the diagram. This information
will be needed later when configuring the
installed EXMs.
Figure E-2. EXP-BP2 Subplane.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com