Specifications

Configuration and Installation
2 2
2-3
JP3 Alive
JP5 FlashJP5 Flash
JP4 BIOS
JP2 Loop JP6 rcvr
Slot 1 Controller Jumper
Figure 2-1. Jumper Locations.
Selecting the EPC-8 Slot Location
There are two main considerations in determining where the EPC-8 should be
positioned in the chassis.
• Per the VMEbus specification (Rule 3.3), the Slot-1 controller must be in
Slot 1. All other boards must be to the right of the Slot-1 controller.
• The EPC-8 connects to its peripherals via a subplane which extends to the
right of the EPC-8. Make sure that the location you choose provides
sufficient room for all the attached peripherals (EXMs and mass storage
module).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com