Specifications

Configuring the Ethernet Drivers

K-3

Then add the following programs into the AUTOEXEC.BAT file:

LSL.COM Link support layer

ATLANTIC.COM Multiple Link Interface Driver

IPXODI.COM IPX/SPX Protocol

NETX.COM (provided by operating system or workstation

distribution diskettes)

While editing the AUTOEXEC.BAT file, make sure that the path= statement

includes the directory containing the NET.CFG file.

The ATLANTIC.COM driver is used for the ODI interface in 16-bit Western Digital

mode and 16-bit NE2000 mode.

The ODI interface does not support IRQ15.

ODI Driver for OS/2 Installation

The steps below outline a typical procedure for accessing the Novell NetWare

Requester using the ODI interface running under OS/2:

1. Open a DOS window.

2. Run AUTOSET. Set the IRQ=3, I/O port address=300, and select the

adapter architecture.

3. Save and exit AUTOSET.

4. Install the OS/2 Workstation Service Requester (1 disk) and the OS/2

Utilities (2 disks) supplied with the Novell Network software.

5. Run INSTALL from C:\NETWARE to select and load

NE2000.SYS. After the installation CONFIG.SYS should contain the

following section:

device=c:\netware\lsl.sys

run c:\netware\ddaemon.exe

device=c:\netware\ne2000.sys

device=c:\netware\ipx.sys

device=c:\netware\spx.sys

run c:\netware\spdaemon.exe

device=c:\netware\nwreq.sys

ifs=c:\netware\nwifs.ifs

run=c:\netware\nwdaemon.exe

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com