Specifications

EPC-8 Hardware Reference
K-2
K
K
NetWare IPX Driver for DOS Installation
The Internet Packet Exchange (IPX) drivers provided with the EPC-8 distribution
diskettes are NE2000.COM and ATLANTIC.COM. The NE2000.COM driver is
used in 8-bit, NE2000 mode with the IPX interface. Once the EPC-8 is configured
using AUTOSET, and the distribution diskettes are loaded onto the system, use a text
editor to modify the AUTOEXEC.BAT file, entering these commands at the end of
the file:
ne2000 /o0 (run ne2000 /d to display available options)
netx.com (provided by network software or operating
system distribution diskettes)
The NE2000.COM driver supplied on the EPC-8 distribution diskettes is
preconfigured for use with the Ethernet 802.3 interface. If your network requires
operating multiple protocols on top of a single card, use the ECONGIF program
provided by Novell to change the NE2000.COM interface setting to Ethernet II.
The ATLANTIC.COM driver is used in 16-bit Western Digital mode with the IPX
interface. Once the EPC-8 is configured using AUTOSET, and the distribution
diskettes are loaded onto the system, modify the AUTOEXEC.BAT file by entering
these commands at the end of the file:
atlantic /o0 (run atlantic /d to display available options)
netx.com (provided by network software or operating
system distribution diskettes)
ODI Driver for DOS Installation
The Open Data-Link Interface (ODI) adds functionality to NetWare and network
computing environments by supporting multiple protocols and multiple LAN adapters
in a single workstation. Refer to the Novell NetWare ODI Shell for DOS manual for
additional installation instructions.
Once the EPC-8 is configured using AUTOSET, and the distribution diskettes are
loaded onto the system, use a text editor to modify the NET.CFG file to match the
AUTOSET parameters. The interrupt, I/O address, mode, and interface type must all
match.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com