Specifications

K-1
K
K
Appendix K - Configuring
the Ethernet Drivers
After the EPC-8 is installed, cabled and configured, follow the instructions in this
chapter to configure the network interface drivers. The distribution diskettes supplied
with the EPC-8 contain drivers for IPX, ODI, NDIS and a packet driver under
DOS/Windows and OS/2.
The majority of users running DOS/Windows select the ODI driver in 16-bit mode, if
supported by their network software.
Most OS/2 users select the ODI driver.
EPC-8 Ethernet support under other operating systems, such as SCO UNIX, LynxOS,
VentureCom VENIX, QNX, etc., is built into the operating system itself and does not
require additional drivers. Use the instructions provided with the network software
package.
The I/O base address, shared memory base address, and IRQ channel used by each
LAN adapter must agree with the values for those parameters that are used by the
adapter's network interface driver. The method used to change the driver parameters
depends on the network operating system software in use.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com