Specifications

Error Messages and Diagnosis
J J
J-11
Not ready reading drive ...
Problem: This is usually caused by not fully inserting a diskette into the floppy
drive.
Solution(s): Eject the floppy diskette and reinsert making sure that the diskette
seats completely into the floppy drive.
Parity error in segment ...
Problem: This could be a software error (reading a nonexistent memory area) or
a true hardware failure.
Solution(s): Attempt to repeat the error. If the error occurs during the execution of
your own proprietary software, verify that the memory location
specified in your software is valid.
Previous boot incomplete - Default configuration used
Problem: Previous Power On Self Test did not complete successfully
Solution(s): Run BIOS Setup and verify the settings and reboot.
Real time clock error
Problem: The battery-backed TOD clock fails the BIOS test.
Solution(s): Run the BIOS setup program to determine what is wrong, and correct
it. If the error occurs repeatedly, the EPC-8's battery may have failed.
System CMOS checksum bad - run SETUP
Problem: Something in the nonvolatile CMOS RAM is incorrect. It has been
corrupted or modified incorrectly, possibly by an application program
that changes stored data in CMOS.
Solution(s): Run the BIOS setup program to determine what is wrong, and correct
it. If the error occurs repeatedly, the EPC-8's battery has failed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com