Specifications

Error Messages and Diagnosis
J J
J-7
Diskette drive A error or Diskette drive B error
Problem: The floppy diskette(s) installed in the system do not match the
configuration information listed in the BIOS setup screen. This may
be due to incorrect entries in the BIOS setup screen or one or both
drives may not be responding at power-up.
Solution(s): Run the BIOS setup program. Make sure the BIOS setup entries
relating to floppy drives correctly reflect the attached floppy drives. If
you are using the EXP-MX module, drive A should be set to "1.4M".
If no second floppy drive is attached, set drive B to NONE. If you
have no floppy drives, both drive A and drive B should be set to none.
Also, verify that all floppy drives are firmly connected (via subplane
or ribbon cable) and that each drive has power.
If you are using an external floppy drive via a front panel connector,
verify that the end of the ribbon cable is not shorting to the front panel
and pin 1 on the front panel connector is connected to pin 1 on the
drive.
Failure - Fixed Disk 0
Problem: The IDE disk controller for drive C cannot be initialized.
Solution(s): If you are using an EXP-MX mass storage module, ensure that the
module is fully seated in the subplane and that the +5V and +12V
LEDs indicate that the module has power.
If you are using the EXM-9 to cable to an external disk, make sure
that you have power to the disk, the ribbon cable is good and correctly
oriented, and that the end of the ribbon cable is not shorting to the
front panel of the EXM-9.
If you are not using an IDE drive, run the BIOS setup program.
Change the drive type to match the device being used.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com