Specifications

EPC-8 Hardware Reference
J
J
J-2
Symptoms Possible cause(s) Solution
System appears to boot
(evidenced by RUN LED
being on, floppy and
hard disk being
accessed) but provides
no video.
If not using the built-in
VGA, then the EXM-
based video adapter may
not be fully seated in
subplane.
Monitor or cable problem
(with or without onboard
video).
Subplane failure or other
hardware failure (with or
without onboard video).
EPC-8 cannot talk to
EXM expansion interface.
Remove the video adapter. If the
subplane is secured to the
VMEbus backplane by retaining
screws, verify that the subplane
is not warped from over
tightening the screws. Reinsert
the video adapter and verify
seating into the subplane.
Verify that the cable pins are not
bent and the cable is fully seated
in the video adapter. If
necessary, try the monitor on
another system to verify that the
monitor is good.
Call RadiSys Technical Support.
Call RadiSys Technical Support.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com