Specifications

AUTOSET Software
H
H
H-9
Error - multiple boot ROM's detected
This error has been automatically corrected
Please re-power the PC to enable the corrections
This message displays when more than one installed Ethernet controller adapter has
enabled a boot ROM. Only one network boot ROM should ever be installed in a PC.
To correct this, the adapter at the lowest address should remain enabled, and all other
adapters should be set for no boot ROM. After saving the changes in the software,
invoke a hardware reset - either push the reset button, or turn the system off, wait ten
seconds, then turn it back on.
Boot PROM changes occur only after cold boot of PC
This message displays following a saved change to the boot ROM configuration. Boot
ROM changes are not in effect until a hardware reset is initiated - either push the reset
button, or turn the system off, wait ten seconds, then turn it back on.
Error - no new adapter
This message displays when the user has attempted to enable a disabled Ethernet
controller, but the software never found the disabled adapter. Either the address is
wrong or the adapter card is faulty.
No interrupt available for configuration
This message displays when there is no free interrupt to assign to the Ethernet
controller. The only solution is to determine where all the interrupts are configured,
and to free an interrupt that is redundant or unnecessary.
Cannot initiate an adapter with a disabled interrupt
This message displays when a disabled interrupt has been selected. Retry with a valid
interrupt selection.
No NIC. DMA Failure
These messages display when a fault is detected in the AT/LANTIC  chip on the
Ethernet controller. This is a fatal hardware error. Contact RadiSys Technical
Support.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com