Specifications

AUTOSET Software
H
H
H-3
The following options are in the main menu: Display/Change Adapter Configuration,
Diagnostics, and Quit.
To initialize an Ethernet controller for the first time, to change the configuration, or to
configure multiple Ethernet controllers, select "Display/Change Adapter
Configuration" in the main menu.
To diagnose problems or verify the configuration, select "Diagnostics."
Note: If more than one Ethernet controller requires configuration for the first time,
see the section Configuring Additional Ethernet Controllers.
Configuring an Ethernet controller with AUTOSET
Figure H-2. Manual Configuration Menu.
For a single Ethernet controller installation, follow these steps:
1. From the AUTOSET program, select "Display/Change Adapter Settings" to set
up the Ethernet controller just installed.
2. Skip the Novell Configuration prompt. It does not apply to the EPC-8.
3. Select the I/O base address. Use the tab key to change the Ethernet controller's
I/O base address to any available location. Note: 300h is recommended because
it allows the use of most network software drivers without modification.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com