Specifications

H-1

H H

Appendix H -

AUTOSET Software

The AUTOSET program is used to configure the Ethernet controller. Since this may

be set up by your supplier, you may never be required to use this program. The

software is contained on the optional Net 1 software diskette that is an optional item

for the EPC-8. The AUTOSET program must be run from DOS or a DOS shell and

enables the following actions:

• Select one adapter to be configured. Up to four adapters may be installed.

• Manually select configuration options (such as I/O base address and IRQ) for

a specific installation.

If configuring multiple Ethernet controller cards in a single system, refer to the

section, "Configuring Additional Ethernet Controllers."

Installing the Software

Under DOS 5.0 or higher, or in a DOS window, insert the optional Net1 distribution

diskette in the floppy drive and switch the command line to that floppy drive.

The DOS INSTALL.BAT file creates a subdirectory on the hard disk and copies the

collection of software drivers and configuration files from the distribution disks to the

hard disk. Type Install and press Enter. Note that AUTOSET can be run from a

floppy disk drive.

The Net1 distribution diskette contains the setup program AUTOSET, and a

collection of drivers for various network interfaces and operating systems.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com