Specifications

Chapter 3: BIOS configuration
39
Boot menu
The Boot menu:
• Specifies the order in which the system tries to boot from devices attached to
the system.
• Specifies the boot order of devices in the same class, such as hard drives.
Boot order is assigned from top to bottom, with the uppermost enabled boot device
in each class being the boot candidate from that device class.
To move an item to a higher level in the list, highlight the item and then press the
“+” key. To move an item to a lower level in the list, highlight the item and then
press the “–” key.
To display all boot device sub-menus under all respective device types, press the Ctrl
and Enter keys at the same time.
To display a sub-menu that lists all devices of a specified type available on the
system, highlight the device type and press the Enter key. If more than one device of
that type exists, use the “+” and “–” keys to change the boot order within the given
device type
To enable a device, highlight the desired device and press the Shift and 1 keys. An
exclamation point ( ! ) displays to the left of enabled devices. To disable a device.
highlight the device, then press the Shift and 1 keys again.
Figure 3-13. Boot menu
Main
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit ←→ Select Menu Enter Select Sub-Menu F10 Save and Exit
+Hard Drive
+ Removable Devices
ATAPI CD-ROM Drive
Network Boot
MBA UNDI (Bus 0 Slot 2)
MBA UNDI (Bus 0 Slot 3)
Main Advanced Exit
PhoenixBIOS Setup Utility
Boot
<Tab>, <Shift-Tab>, or <Enter>
selects field.
Item Specific Help