Specifications

EPC-2 HARDWARE REFERENCE
Message interrupt 40
Message Low Register 31, 37, 38
Message register 38
Message-based device 35
Mode command 64
Model code 35
MODID 3, 4, 7, 35
MODID / Interrupt Generator Register
32, 42
MODID jumper 6
MODID Upper Register 32, 42
Module Status/Control Register 32,
44, 50, 53, 54
Monitor 9, 60
Monitor cables 9
Monitor port 59
Monitor problems 10, 60
Monitor type 45
Mouse 10
MS-DOS 10, 21
MSC 44, 50, 54
MSGR interrupt 37, 40
Multiscan monitor 9
No SYSCLK error 7
Non-operating temperature 56
Non-system disk error 65
Nonvolatile option register 36, 45
Not ready error 65
Operating temperature 56
P1 connector 53
P2 connector 53
Page tables 50
Parallel port 11, 58
Parallel port mode 17, 20
Parallel port setup 20
Parity 51
Parity error 65
Park 19
Partition table 63
PC-DOS 21
PC/AT I/O bus 53
PCbus add-in card 55
Pipelined write 46
Plasma display 9, 59
POS register 36, 44, 45
Power consumption 56
Printer port 1, 11
Printer port setup 20
Priority arbitration 19
Priority levels 19
Protocol register 37
Protocol/Signal Register 31, 37
Read ready 37
Real time clock error 65
Reapplying power 13
Release on request 19
Repair service 67
Request on no request 19
Reset 36, 44, 53
Reset switch 13, 14, 54
Resource manager 6, 35
Response Register 31, 37, 38, 39, 40,
44
Revised model 2
RMA 67
RMW cycle 48, 50
ROM shadowing 51
RONR 19
ROR 19
Round-robin arbitration 19
RS-232 10
Run LED 14, 54
Scanner 11, 20
SCSI 15
SCSI controller 52
SCSI failure 16
SCSI formatting 22
SCSI setup selection 18
Security keys 11
Page 71
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com