Specifications

EPC-7 Hardware Reference
ÿ Position the add-in card inside the EPC7-AM as shown in Figure C-3 above.
Slide the add-in card toward the front panel until the metal end-panel of the
add-in card is past the card-edge connector. Then move the add-in card
down and slide it forward again to allow the flange on the top of the metal
end-plate to pass through the slot in the front of the EPC7-AM as shown in
Figure C-3.
CC
ÿ Slide the add-in card down so the care-edge inserts into the card-edge
connector. Make sure that the tab on the bottom of the metal add-in card end
plate seats into the retainer slot of the EPC7-AM as shown in Figure C-4
below.
Retainer Slot
PC Add-In Card
EPC7-AM
Front Panel
A
dd-In Card
End Plate Tab
Figure C-4. Cut-Away Diagram Showing Retainer Slot.
Page C4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com