Specifications

EPC-7 Hardware Reference
First, set any jumpers or switches on your add-in card. Make sure that any selections
you use for IRQ levels, base addresses, or DMA channels do not conflict with the
EPC-7 or any EXMs already installed. Be especially careful about cards that are
software configurable. Consult the EPC-7 and EXM module manuals if necessary. If
there are conflicts, your add-in card may not be recognized by the system.
CC
Lay the EPC-7/EPC7-AM assembly on a static-free work surface with the EPC7-AM
side up and the front panel to your left as shown in Figure C-1 below. This will
position the bottom of the assembly closest to you.
P1 Connector
(top)
Front
Panel
Figure C-1. EPC-7/EPC7-AM Orientation.
ÿ Remove the 8 side panel screws shown in Figure C-1 above. Set these
screws aside for now. You will need them later.
ÿ If you are installing a full size add-in card (long card), you will need to
temporarily remove the rear panel of the EPC7-AM. Remove the 4 screws
shown in Figure C-2 below.
Page C2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com