Specifications

B
IPMI Commands and Managed Sensors
34
Managed sensors
TheRTMmanagessensorswithsensordata record(SDR)support.TheRTMimplementsa
Type12h(0x12)managementcontrollerdevicelocatorrecordforidentifyingthe
managementcontrollerandaType1h(0x01)fullsensorrecordfordescribingthesensor.
Ratherthanbeinganactualphysicalcomponent,somesensorsareanaccumulationofthe
informationgatheredbythemeasuringdevicesandtheMMContheRTM.TheMMC
monitors conditionsanddetectsdigitalstatechangesoranalogvaluescrossingthresholds.
Whenatransitionoccurs,theMMCsendstheinformationtotheCPM’sIPMC,whichforwards
ittotheShelfManagerasanevent.TheShelfManagermayinturnsendtheeventtoasystem
manager.
Get Device Locator Record ID PICMG (0x2C) 0x0D
Set AMC Port State PICMG (0x2C) 0x19
Get AMC Port State PICMG (0x2C) 0x1A
FRU Control Capabilities PICMG (0x2C) 0x1E
Get Target Upgrade Capabilities PICMG (0x2C) 0x2E
Get Component Properties PICMG (0x2C) 0x2F
Abort Firmware Upgrade PICMG (0x2C) 0x30
Initiate Upgrade Action PICMG (0x2C) 0x31
Upload Firmware Block PICMG (0x2C) 0x32
Finish Firmware Upload PICMG (0x2C) 0x33
Get Upgrade Status PICMG (0x2C) 0x34
Activate Firmware PICMG (0x2C) 0x35
Query Rollback Status PICMG (0x2C) 0x37
Initiate Manual Rollback PICMG (0x2C) 0x38
Table 13. Supported IPMI commands (continued)
Message Commands NetFn Cmd