Specifications

2
Installing FRUs
13
Updating the drive information record
Ifyouareinstallinganewharddiskdriveorreplacinganexistingone,usethermcpta
commandtoensurethedriveinformationrecordfortheMMChasthecorrectharddiskdrive 
typewhentheRTMresetsafteritisinsertedintothechassis.
Important:Toensurecompatibilitywiththecommandsinthisprocedure,usetheversionof
rmcptathatisprovidedwiththelatestRadisyssoftwarerelease.
1. Invokermcpta,specifyingtheShelfManagerIPaddress:
rmcpta‐h<ShMgrIPaddress>
2. Setthecontrolleraddresswheremessagesareforwarded,specifyingthefrontmodule
slotIPMBaddressandtheIPMB‐LaddressoftheRTM:
targetfwd<FrontmoduleslotIPMBaddress><RTMIPMB‐Laddress>
3. UpdatethedriveinformationrecordintheFRUdatawithdataaboutthenewharddisk
drivetobeinstalled.
setdriveinfo
4. Thesetdriveinfocommandpromptsyoutocompletethefollowingfields:
Enterthenumberofdrivesinstalled():1
Enterthedrivetype,0‐FC,1‐SATA,2‐SAS,0xFF‐None(0xFF):2
Enterdrivemanufacturername():
Enterdrivemodel():
Enterdriveserialnumber():
Enterthedesirednumberofcustominfofields():0
Theenteredinformationisdisplayedtoverifytheentries:
#RadisysRecordID=0x0ADriveInformationRecord
#RecordFormatVersion=0x00
#DriveNumber1
#DriveType=SAS(0x02)
#ManufacturerName=
#Model=
#SerialNumber=
Writethedatatothedevicebyenteringyes:
Writethedatatothedevice?[yes/no]yes
WritingthedatabacktothedeviceFRU0informationarea...
DetectedsupportofRadisysOEMGroupWriteFRUDatacommand.(0x2E0x0A)
TheMMCnowreportsthecorrectdrivetype.