Specifications

2
Installing FRUs
12
Figure 2. HDD installation
Mounting the hard disk drive and sled onto the RTM
1. Alignthefoursledkeyholescrews overtheRTMkeyholesandsimultaneouslyguideall
fourscrewsdownintothekeyholes.
2. SlidethesledalongthekeyholeslottowardtheRTMfaceplateandthentowardtheRTM
SAS/SATAconnector.See
Figure2.TheharddiskdriveSASconnectormateswiththeRTM
SAS/SATAconnector.
3. SecurethesledtotheRTMbytighteningtheretainingscrewwithascrewdriver.
Inserting the RTM into the chassis
Aftertheharddiskdriveisinstalled,inserttheRTMintothechassisintherearslot
correspondingtotheassociatedfrontmoduleCPM.
Retaining screw
SAS/SATA connector
Mounting screw
Keyhole
SAS/SATA connector
Keyhole screw
Hard disk drive (HDD)
Drive sled