Specifications

3
Using rsys-update for single product updates
35
4. Updatethestandbyflashbank:
rsys‐update‐‐path/<tmp‐dir>/<update‐bundle>‐‐automatic
Thisresultsinareboottothestandby(newlyupdated) flashbank.
5. Forlocalmanagementprocessor(LMP)modules,confirmthenewversionworks
correctly:
flashver‐‐secondary
6. Downloadtheupdatebundleagain,sincethetemporarystoragewaslostuponreboot.
Refertotheprevioussectionfordetailedinstructions.
7. Flashtheremaining(originalactive)flashbank.
rsys‐update‐‐path/<tmp‐dir>/<update‐bundle>‐‐automatic
Thisresultsinareboottotheoriginalactive(nowupdated)flashbank.
8. Repeattheupdateprocessforredundantprogrammabledevicesinordertoflashthe
secondbank.ThissecondupdateisrequiredfortheATCA‐43xxbecausetheredundant
BIOSfeaturerequiresbothBIOSbankstobeatthesameversion.
Updating non-redundant devices
Runthersys‐updateutilityagainandspecifythe‐‐non‐redundantoptiontoupdateanynon‐
redundantdevices.Examplesinclude:
•BoardIPMCFRUdata(ATCA‐4300,ATCA‐4310,ATCA‐4500,ATCA‐4550,ATCA‐4555,ATCA‐
1200,ATCA‐2210,ATCA‐7220,ATCA‐9100)
•ATCA‐7220DPBFPGAandsoftware
•AMC‐7211andAMC‐7212bootflash
SeeTable 1onpage 10forafulllistingofredundantandnon‐redundantdevicesforeach
product.
Toupdateamodule’snon‐redundantdevices:
1. Usethedry‐runoptionofrsys‐update.Thiscommanddisplaysasimulationoftheupdate
procedureandidentifiesthetargetednon‐redundantdevices.
rsys‐update‐‐path/<tmp‐dir>/<update‐bundle>‐‐dry‐run‐‐automatic‐‐non‐
redundant
2. Updatethenon‐redundantdevices:
rsys‐update‐‐path/<tmp‐dir>/<update‐bundle>‐‐automatic‐‐non‐redundant
Forexample,thefollowingcommandupdatesthedeviceusingthefactoryrecommended
orderandoutputsalogfileifanyerrorsoccur:
rsys‐update‐‐path/tmp/rsys‐update/ATCA‐4300‐2.3.13‐2‐rh‐firmware/‐‐
automatic‐‐non‐redundant‐‐log‐filelogfile
3. Afterthereboot,enterthiscommandtoconfirmthenewversion:
rsys‐update‐‐path/<tmp‐dir>/<update‐bundle>‐‐versions‐‐non‐redundant