Specifications

B
Supported IPMI commands
99
1
Completion code flags for bits 2, 3, 4 and 6 of byte 3 are not supported for the CPM, so those bits should be
0. See the Intelligent Platform Management Interface Specification v1.5 for details about the Get Self Test
Results completion codes.
2
See OEM command descriptions on page 100.
Compute Power Properties PICMG (0x2C) 0x10
Set Power Level PICMG (0x2C) 0x11
Get Power Level PICMG (0x2C) 0x12
Bused Resource PICMG (0x2C) 0x17
Set AMC Port State PICMG (0x2C) 0x19
Get AMC Port State PICMG (0x2C) 0x1A
Set Clock State PICMG (0x2C) 0x2C
Get Clock State PICMG (0x2C) 0x2D
Get Target Upgrade Capabilities PICMG (0x2C) 0x2E
Get Component Properties PICMG (0x2C) 0x2F
Abort Firmware Upgrade PICMG (0x2C) 0x30
Initiate Upgrade Action PICMG (0x2C) 0x31
Upload Firmware Block PICMG (0x2C) 0x32
Finish Firmware Upload PICMG (0x2C) 0x33
Get Upgrade Status PICMG (0x2C) 0x34
Activate Firmware PICMG (0x2C) 0x35
Query Self Test Results PICMG (0x2C) 0x36
Query Rollback Status PICMG (0x2C) 0x37
Initiate Manual Rollback PICMG (0x2C) 0x38
Restore Factory Defaults
2
RadiSys OEM (0x30) 0x05
Disable CFD
2
RadiSys OEM (0x30) 0xE7
Set WDT Reset Type
2
RadiSys OEM (0x30) 0xA8
Get Control State (for debug only)
2
RadiSys OEM (0x30) 0x21
Set Control State (for debug only)
2
RadiSys OEM (0x30) 0x20
Switch Active Boot Flash
2
RadiSys OEM (0x30) 0xA9
Get Active Boot Flash
2
RadiSys OEM (0x30) 0xAA
RTM Reset Button
2
RadiSys OEM (0x2E) 0x15
Set Payload Status
2
RadiSys OEM (0x2E) 0x20
Get Payload Status (for debug only)
2
RadiSys OEM (0x2E) 0x21
Table 33. Supported IPMI commands (continued)
Message commands NetFn Command