Specifications

2
Installing the memory cards
19
Installing the memory cards
1. OpentheDIMMsocketejectorlatchesbypushingthemoutward.SeeFigure 4.
Figure 4. DIMM sockets
2. TheDIMMsarek eyedsotheycanbeinsertedinonlyoneway.HoldtheDIMMbythe
edges,aligntheslot(keyway)oftheDIMMwiththetabmoldedinthebaseofthe
socket,andpushthecarddownfirmlyintothesocket.Theejectorlatchescloseand
theDIMMclicksintoplacewhenitisfirmlyseated.
3. InserttheotherDIMMsinthesamemanner,rememberingtofillthecorresponding
DIMMslotforcorrectchanneloperation.
4. ScrewtheDIMMcoverplatebackintoplace.
5. InstalltheCPMintheshelf,thenpowerupthemoduleandchecktheBIOSscreensto
verifyallmemoryisworking.SeeTestinginstalledmemoryonpage 20.
Replacing DIMMs
TheseinstructionsassumetheCPMhasbeenremovedfromtheshelfandtheDIMM
coverhasbeenremoved.SeeRemovingtheDIMMcoveronpage 18.
W
ARNING! Observe appropriate ESD precautions when performing these procedures (see
Electrostatic discharge on page 8).
1. DeterminewhichDIMMstoremove(seethepreviousdiscussionunderSupported
DIMMcombinations).
2. PressoutwardontheDIMMsocketejectorlatchestopopoutaDIMM,asshownin
Figure 4onpage 19.HoldtheDIMMbytheedgesandremoveit.Removetheother
DIMMsinthesamemanner.
3. ToreplacetheDIMMwithanewcard,followthestepsunderInstallingthememory
cardsonpage 19.
DIMM socket
Ejector latch