Specifications

F
Troubleshooting
169
Troubleshooting
Table 56listsbioscli2erro rmessages,alongwithadescriptionoftherelatederror
conditionandthecorrectiveaction.
Table 56. bioscli2 error messages
Error message Error condition Corrective action
insmod:can’tread‘/lib/modules/
xxx/extra/smiflash/
smiflash_mod.ko’
The smiflash driver is not installed
properly.
1. Make the smiflash driver that is embedded into the
bioscli2 binary (bioscli2 v1.05 and above only) by
entering this command:
bioscli2‐m[optional]/lib/modules/
$(uname‐r)/build]
Note: Kernel headers are required to make the smiflash
driver.
2. Copy the driver to:
/lib/modules/kernelxxx/extra/smiflash/
smiflash_mod.ko
FreshBIOSROMfiledetected.
Pleaserebootthesystemforthe
newBIOStotakeeffectfirst.
When a fresh BIOS ROM file with
cleared NVRAM is detected, a
reboot and an F3 Load Defaults
command is required in the BIOS
setup menu.
Reboot the system and run the Load Defaults command.
Pleasereboottheboardforthe
defaultstotakeeffect.
A reboot is required when
bioscli2‐d is entered.
Reboot the board.
Erroropeningfile/decodingBIOS
file.
An unexpected error occurred.
The BIOS is either corrupted or
bioscli2 is failing.
Reflash the BIOS with a new image. If the problem
persists, contact RadiSys Support.
BIOSisUser/Adminpassword
protected.EnterUser/Admin
passwordtocontinue.
BIOS is password protected,
which is set in the BIOS setup
menu.
You must have the right privileges to manipulate BIOS
setup settings.
"BIOSCLI2ITEM"hasinvalid/
incorrectvalue/range/notfound/
duplicates.
An incorrect value was entered
for the intended item to be set.
Use bioscli2‐l to list the intended item to be set with
its correct values.