Specifications
B
OEM command descriptions
103
Get Payload Status (debug only)
Returns the H8 IPMI firmware acknowledgement of the payload processor status. The BIOS/OS
uses this command to check if the IPMI firmware finished the internal processes for the x86
processor complex boot phase specified in a sent
Set Payload status command.
The IPMI firmware reports boot phase 1 is complete after it has initialized all appropriate control
signals to yield access of all hardware shared resources to the onboard x86 processor complex. It
reports boot phase 4 is complete after reconfiguring the appropriate control signals to regain access
of all hardware shared resources and commencing the applicable management functions..
Byte 6 Status Byte 2
Bits 7:0 = Reserved
Response field Byte 1 Completion code
Byte 2 Radisys IANA PEN0: F1h
Byte 3 Radisys IANA PEN1: 10h
Byte 4 Radisys IANA PEN2: 00h
NetFn 0x2E
Cmd 0x21
Data field Byte 1 Radisys IANA PEN0: F1h
Byte 2 Radisys IANA PEN1: 10h
Byte 3 Radisys IANA PEN2: 00h
Byte 4 Command Version: hard coded to 0x00
Response field Byte 1 Completion code
Byte 2 Radisys IANA PEN0: F1h
Byte 3 Radisys IANA PEN1: 10h
Byte 4 Radisys IANA PEN2: 00h
Byte 5 Command version
Byte 6 Status byte 1
Bits 7:4 = Reserved
Bit 3 (Boot Phase 4) = 0b (Not Complete) 1b (Complete)
Bit 2 (Boot Phase 3) = 0b (Not Complete) 1b (Complete)
Bit 1 (Boot Phase 2) = 0b (Not Complete) 1b (Complete)
Bit 0 (Boot Phase 1) = 0b (Not Complete) 1b (Complete)
Byte 7 Status byte 2
Bits 7:0 = Reserved