Specifications

Configuring Shelf Manager and HPI Behavior

Changing the Shelf Manager operating mode

TheShelfManagerinanATCA‐6002shelfcanoperateintwomodes:enhancedandbasic.For

adescriptionoftheseoperatingmodes,refertoBasicandenhancedshelfmanagement

operationonpage 24.Bydefault,theShelfManagerrunsinbasicmodeformostofthe

modules.Theex ceptiontothisaretheATCA‐45xxseriesandtheATCA‐46xxseriesCPMs,

whichonlyoperateinenhancedmode.

Tochangetheoperatingmode:

1. Establishaserialconnectiontothemoduleandlogonasroot.SeetheInstallationGuide

fordetails.

2. Tochangetoenhancedmode,enter:

rsys‐ipmitoolrsysoemshmcenhanced<address>

Forexample,toenableanATCA‐7220inslot1ofanATCA‐6002shelf:

rsys‐ipmitoolrsysoemshmcenhanced0x82

3. Toverifythatthemodule’sShelfManagerisenabledinenhancedmode,enter:

rsys‐ipmitoolrsysoemshmcinfo

IftheShelfManagerisenabledinenhancedmode,theresponseisShMCstate:Enhanced

mode

4. Tochangebacktobasicmode,followthesestepsagainandenterthiscommandinstead:

rsys‐ipmitoolrsysoemshmcbasic<address>