Specifications

C
Appendix
142
IPMI Commands and Managed Sensors
Supported IPMI commands
TheShelfManagersupportsallIPMIcommandslistedintheAdvancedTCABaseSpecification.
Note:
•OntheATCA‐6002shelf,theGetTelcoAlarmLocationcommanddoesnotreturnavalid
locationbecausenotelcoalarm siteexistsonthisshelf.AllotherIPMIcommandsare
supportedontheATCA‐6002shelfwhentheShelfManagerisrunninginenhancedmode.
•DonotusethePICMG“FRUcontrol”commandwiththecoldresetoptiontoresetAMCs
installedintheATCA‐1200.DoingsowillresettheentireATCA‐1200module.TheHPI
saHpiResourceResetStateSet()functionalsousesthePICMG“FRUcontrol”commandand
willcausetheATCA‐1200moduletoreset.
Sensors managed by the Shelf Manager
ThissectionliststhelogicalsensorsthataremonitoredbytheShelfManager.Theseinclude:
•WhentheshelfhasredundantSCMs,thesetoflogicalsensorsoneachSCMthatindicate
thestatusoftheactiveandstandbyShelfManagers.SeeTable 18onpage 143.
•ThesetofHPI‐definedlogicalsensorsforeachFRUthatindicatesthestatusoftheFRU.
SeeTable 19onpage 144.
•TheHPI‐definedlogicalsensorforeachshelfthatindicatestheminimumfanspeed.See
Table 20onpage 146.
Note:ThesesensorsaresupportedontheATCA‐6002shelfonlywhentheShelfManageris
runninginenhancedmode.