Specifications

A
Appendix
80
Specifications
TheRadisy sATCA‐46xxCPMcomplieswithormeetsthestandardsandspecifications
pre sentedinthefollowingsections.
Standards and interfaces
Table 19liststhestandardsandinterfacesthatapplytotheCPM.
Table 19. CPM Standards and Interfaces
Standards/Interfaces Description
Standards • PICMG 3.0 R3.0.1 AdvancedTCA
• PICMG 3.1 R2.0 AdvancedTCA Ethernet option 1/9
• European requirements for hazardous materials, ROHS 6/6
Networking • Intel® I350 Quad Gigabit Ethernet controller
• Four 10/100/1000BASE-T ports (two on front panel and two on Base
Interface channels 1-2)
• Two SMGII/SerDes ports on Zone 3 connector to the RTM
• Dual 40GBASE-KX4 Fabric Interface Channels controlled by
Mellanox CX3 dual 40GbE controller
Serial ATA (SATA) Five Serial ATA II ports from PCH, one onboard, four to RTM
Serial Attached SCSI (SAS) Three SAS ports from LSISAS1064E to RTM
Video interface •
USB interface Two USB 2.0 ports on front panel, two ports available on-board, four
ports to RTM
Serial interface One front panel RJ-45 RS-232 port
Mass and Non-Volatile Storage • On-board 4GB USB NAND Flash
• Four SATA and three SAS ports on RTM
Front Panel I/O • 1x VGA port (DB-15)
• 3x USB 2.0 port (Type-A)
• 1x RS-232 port (RJ45)
• 2x GbE ports (RJ45)
• LEDs: OOS, Media, User, Hot Swap, and Base/Fabric status
• Recessed reset button
Rear I/O (to RTM) • PCI-E x4 from Intel C600 series PCH
• 1x COM port
• 4x USB 2.0 ports
• 4x SATA ports from ICH10R
• 3x SAS/SATA ports from LSISAS1064E
• 2x SerDes ports