User manual

Chapter 1
Overview
1-2
Figure 1.1
Examples of PLC-5/VME Processors
Battery low
Proc run/Fault
Force
Ch 0 Status
SYSFAIL
Master Access
Slave Access
Battery low
Proc run/Fault
Force
Ch 0 Status
SYSFAIL
Master Access
Slave Access
Battery low
Proc run/Fault
Force
Ch 0 Status
SYSFAIL
Master Access
Slave Access
Battery installed
Chan 0
Chan 2
Chan 1
Battery installed
Chan 0
Chan 2
Chan 1
19499
PLC-5/V40B or -5/V80B processor PLC-5/V40L processor
Program
Remote
Run
Program
Remote
Run
1A
1B
1A
1B
Battery installed
Chan 0
Chan 1
PLC-5/V30B processor
Program
Remote
Run
1A
1B
All PLC-5/VME processors have at least one configurable I/O channel and
one serial port (channel 0).
Channel: Is configured for:
0 supporting RS-232C
The PLC-5/VME processor channel 0 protocol defaults to the system mode of
operation (DF1 point-to-point), which allows programming from a PC terminal.
The default communication rate is 2400.
1A DH+ mode (by default)
1B scanner mode (by default)
2 (if applicable) DH+ and remote I/O (RIO) communication or extended-local I/O